![]() ![]() Saving all your work for eventual crashes/freezes/restarts before handling system configuration is always good idea. There is no guarantee that this process will not damage your system permanently, I just think that chance of such critical failure is really really low. (Potentially, this can damage your system or cause system crash. In terminal type sudo sensors-detect and answer YES to all YES/no questions. Install the lm-sensors and fancontrol packages. If it does, but the software (aka kernel) doesn't know how to control it, you are without luck. If your hardware doesn't support fan speed controls, or doesn't show them to the OS, it is very likely that you could not use this solution. The Reset() method is called when the control is disabled and should return back to its default state.This functionality depends on both your hardware and software. The Set( val ) method should activate your control and apply the value to it. ![]() IPluginControlSensor (inherits IPluginSensor)Ī control sensor controls sets a value to a fan ( or whatever else ) from a fan curve. Update the value of your sensor in that method from whatever source you are using. The Update method is called internally by the FanControl backend every update cycle, which right now is 1 Hz. Use this method if you want a single hook to update all your sensors from a single method instead of updating from every sensor. ![]() New implementation that inherits IPlugin and adds
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |